Table of Contents
Advertisement
Press the "Ready in" time button or
9.
the drying time button to change the
volume.
Turn the programme selector
10.
clockwise to position 5.
The current is shown in the display.
11.
LO = 10 A
HI = 16 A
Press the "Ready in" time button or
12.
the drying time button to change the
current.
Exiting setting mode
Turn the programme selector to the
"Off" position once you have set the
required spin speed, volume or fuse
current rating. The settings have now
been saved.
D
Cleaning
C leaning the dryer and the
C l e a n i n g
control panel
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Disconnect the dryer from the mains
before cleaning.
Clean the dryer using only water and a
soft, damp cloth.
Remove all detergent residue, spray
residue or other residues immediately.
Do not use cleaning agents or agents
for pre-treating laundry (e.g. prewash
sprays, stain removers). Do not use
high-pressure cleaners or steam jet
cleaners to clean your appliance.
Cleaning the heat exchanger
Notes
Clean the heat exchanger several
■
times a month if you use the dryer
more than twice a week.
If there is debris in the heat
■
exchanger, this will increase the
amount of time required for drying
and will compromise the drying
results.
Allow the dryer to cool down and
1.
place an absorbent cloth beneath
the maintenance flap.
Residual water may leak out.
Note:
Open the maintenance flap fully.
2.
Turn both locking levers towards
3.
each other.
Remove the top cap from the heat
4.
exchanger.
Cleaning
en
29
Advertisement
Table of Contents
