Philips FC9920/09 Important Information Manual page 6

ENGLISH
6
Problem
The suction
power is
insufficient.
When I use my
vacuum cleaner I
sometimes feel
electric shocks.
The infrared
remote control
does not
function.
Possible cause
The dust container is
full.
The filters are dirty.
The suction power is
set to a low setting.
The nozzle, tube or
hose is blocked up.
Your vacuum cleaner
builds up static
electricity. The lower
the air humidity, the
more static electricity
the appliance builds up.
The batteries do not
make full contact or
have not been inserted
properly.
The batteries are
empty.
Solution
Empty the dust container.
Clean or replace the filters.
Increase the suction power with the regulator on
the appliance or on the handgrip.
To remove the obstruction, disconnect the blocked-up
item and connect it (as far as possible) the other way
around. Switch on the vacuum cleaner to force the air
through the blocked-up item in opposite direction.
Discharge the appliance by frequently holding the
tube against other metal objects in the room (for
example the legs of a table or chair, a radiator etc.).
You can also raise the air humidity level in the room.
Remove the lid of the battery compartment and
insert the batteries correctly. Make sure the - and +
poles point in the right direction.
Replace the batteries. You can continue to vacuum
but you cannot use the remote control to increase
or decrease the suction power or to switch off the
appliance. To switch off the appliance, press the on/
off button on the appliance.