Before Brewing Your First Pot; Programming Your Coffee Brewer - Cuisinart PurePrecision CPO-800 Instruction Booklet

BEFORE BREWING YOUR
FIRST POT OF COFFEE
RINSING YOUR COFFEE BREWER:
We recommend flushing out the system
before brewing your first pot of coffee. Simply
fill the reservoir, power on the unit, and follow
steps 1, 3 and 5 on page 9 under MAKING
COFFEE. Do not add coffee!
Charcoal Water Filter
Your coffee brewer comes with a charcoal
water filter that eliminates chlorine, bad
tastes and odors from tap water.
Inserting the Water Filter
• Remove the filter from polybag and soak it,
fully immersed, in cold tap water for 15
minutes.
• Lift the water filter holder out of the water
reservoir.
• Press down on the filter compartment and
pull toward you to open.
• Place filter into the holder and snap it
closed. Be careful – improper placement
can tear the filter skin.
• Flush filter by running cold tap water
through holes in bottom of compartment
for 10 seconds.
• Allow the filter to drain completely.
• Slide the water filter holder back into the
channel in the water reservoir, pushing it
down to the base of the unit
NOTE: We recommend
changing the water filter
every 60 days or after 60
uses, and more often if
you have hard water.
Replacement filters can
be purchased in stores, or by
calling Cuisinart Customer
Service, or at
www.cuisinart.com
.
8
PROGRAMMING YOUR
COFFEE BREWER
SETTING THE CLOCK
When the coffee brewer is plugged in, 12:00
will flash in the display for 30 seconds,
indicating the unit is in Clock Set mode.
If 12:00 stops flashing, simply press the
menu button 4 times to the clock option and
the time will return to flashing Clock
Set mode.
SETTING HOURS AND MINUTES
Use the up arrow
down arrow to set minutes. Hold buttons
down to scroll through the digits quickly, or
press and release to advance one digit at a
time. Be sure the PM indicator is on if setting
a PM time. Once time is correct, press MENU
to set, or five seconds after finishing, the unit
will automatically exit Clock Setting mode.
AUTO ON FUNCTION
1. To set AUTO ON brew time:
Press and hold the Auto On button for
2 seconds. The digital display will flash the
default (12:00) or previously selected time
and the AUTO ON button will flash. Follow
directions under SETTING THE CLOCK
(above) to program your start-brew time.
Five seconds after finishing, the unit will
automatically exit Auto On Setup mode.
AUTO ON will appear on the control panel
and the AUTO ON button will illuminate
indicating AUTO ON is activated.
NOTE: To exit Auto On Setup mode, you
can also just press Auto On button again.
2. To reactivate Auto On feature:
To start at the same time on another day,
simply press the AUTO ON button. The
time will appear, release button and AUTO
ON will appear on control panel and AUTO
ON button will be illuminated.
3. To deactivate Auto On:
Press illuminated Auto On button; AUTO
ON will not be displayed on control panel
and AUTO ON button light will turn off.
to set hours and the