Replacing The Filter - ProBreeze PB-07-US Instruction Manual

FILLING WATER TANK AND SWITCHING ON
1. Lift the water tank off using the handle beneath the mist lid.
2. Turn the water tank upside down and unscrew the water tank cap. The cap forms
part of the water filter which helps to eliminate contaminants in the water.
3. Fill the water tank with cold water.
4. Screw the water tank cap back onto the tank.
5. Place the water tank back onto the base. Be sure to align the base correctly so it
secures into place.
6. Place the mist lid on top of the water tank and plug the power cord into an
electrical outlet.
7. Turn the humidifier on by turning the dial clockwise. The power indictor light will
turn on.
8. Within a few seconds the mist will start coming through the mist lid. Use the
control dial to control the intensity of the mist.
9. Turn the LED light on by pressing the LED button.
Note:
When the humidifier runs out of water the
power indicator light will turn red and the
mist will stop.
Do not move the humidifier once you have
installed the water tank onto the base as this
could cause water to leak.

REPLACING THE FILTER

The ceramic ball filter is designed to remove
impurities from the water and ensure it stays
clean for as long as possible. We
recommend replacing your filter at least once
every 6 months or 500 hours of use. The filter
forms part of the water tank cap so to
replace it, simply unscrew it from the water
tank and install the replacement.
3 | English