Setting The Salt Consumption; Rinse Agent - ETNA EVW8262 Instructions For Use Manual

OPERATION

Setting the salt consumption

Rinse agent

EN 14
softener indicator lights up. It is possible that the light will remain
lit for a short while after the salt reservoir is filled. It will go out
automatically when enough salt has been dissolved in the water.
• Never fill the salt reservoir with dishwasher detergent. This will
cause irreparable damage to the water softener.
1. Unscrew the cap from the salt reservoir.
In de opening of the reservoir, you will find a ring bearing an arrow.
2. Turn the ring towards - or +, depending on the hardness of the
water.
Adjust the salt consumption according to the table below:
Water hardness
degrees ºdH mmol/l
Clarke
0 - 10 0 - 8 0 - 1.4
10 - 28 8 - 22 1.4 - 3.9
28 - 56 22 - 45 3.9 - 8
56 - 75 45 - 60 8 - 11
Your local water authority can inform you how hard your mains water is.
Adjustments can then be made according to the table.
Rinse agent is added during the final rinse. Rinse agent prevents traces
of water droplets being left behind on the clean dishes. Moreover, it
ensures that the dishes dry quicker, since the water drains off more
easily.
The dishwasher is designed for use with liquid rinse agent. The rinse
agent reservoir is located on the inside of the door, alongside the
detergent compartment.
Setting Salt
consumption
(grams/cycle)
No salt 0
required
- position 20
Central 40
position
+ position 60
Autonomy
(cycles/1 kg)
/
50
25
16