Inerrupting And Chanching The Program - Pelgrim PWM121WIT Detailed Instructions

INERRUPTING AND CHANCHING
THE PROGRAM
Manual (physical) termination
The program can be cancelled / terminated
by rotating the program selector dial (1) to
the position. "0FF" position.
If there is water in the machine, select the
additional program (spin + DRAIN) key (4)).
Personal settings
To save the most frequently used program
Select the program and the settings, and
save it as a present by holding the START/
PAUSE key for 8 seconds. CHD will appear
on the display.
The program will remain stored until it is
changed (using the same procedure).
PAUSE KEY
The program can always be stopped by
pressing the START/PAUSE. If there is no
water in the drum, the door can be opened
after a while; otherwise, the door cannot be
opened. To resume the program, press the
START/PAUSE key.
34
If a power failure occurs when the drum is still full of water, be
careful not to open the door before you pump the water out.
(see Programs/partial programs: Spinning/pumping).
FAULTS
In case of a fault, the program will be
interrupted. Flashing signal lights and
an acoustic signal will warn about such
occurrence (see section Troubleshooting),
and the fault will be indicated on the display
(ERR).
Power failure
At electric cutout the program is
interrupted. When the power supply is re-
established, press the START/PAUSE key to
resume the washing program.
Washing time will resume from the point at
which it was interrupted.