Table of Contents
Advertisement
Positioning and connecting
en
– The water drains away quickly
enough.
Drainage into a siphon
■
The connection point must be
secured using a hose clamp with a
diameter of 24-40 mm (available
from specialist dealers).
Outlet into a plastic pipe with
■
rubber bushing or into a drainage
pit
Levelling
Level the appliance using a spirit level.
Incorrect levelling may result in intense
noise, vibrations and "wandering".
Loosen the lock nuts using a
1.
wrench, by turning it in a clockwise
direction.
Check the alignment of the washing
2.
machine with a spirit level, and
adjust it if necessary. Change the
height by turning the appliance feet.
All four appliance feet must stand
firmly on the ground.
30
Tighten the lock nut against the
3.
housing.
In doing so, hold the foot tight and
do not adjust its height.
The lock nuts on all four appliance
feet must be screwed tightly against
the housing.
Electrical connection
:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
Never touch or hold the mains plug
■
with wet hands.
Only pull out the mains cable by the
■
plug and never by the cable, as this
could damage it.
Never unplug the mains plug during
■
operation.
Observe the following information and
ensure that:
Notes
The mains voltage and voltage
■
indicated on the washing machine
(rating plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
The mains plug fits the socket.
■
The cable cross-section is adequate.
■
The mains cable is only replaced by
■
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
■
extension cables are used.
Advertisement
Table of Contents
