Water Outlet - Bosch WAK20060SG Instruction Manual And Installation Instructions

Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may be
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow is
at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Connection
Connect the water supply hose to
1.
the water tap (¾" = 26.4 mm) and to
the appliance:
– Model: Standard
– Model: Aqua­Secure
Open the water tap carefully,
2.
checking the leak tightness of the
connection points. The screw
connection is under mains water
pressure.
Positioning and connecting

Water outlet

Caution!
Water damage
If the drain hose slips out of the wash
basin or the connection point during
draining due to high water pressure, any
escaping water may cause water
damage.
Secure the drain hose so that it cannot
slip out.
Do not kink the water drain hose
Note:
or put strain on it lengthways.
You can lay the water drain hose as
follows:
Outlet in a sink
■
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of
scalding if you come into contact
with hot detergent solution e.g. if hot
detergent solution is being drained
into a wash basin.
Do not reach into the hot detergent
solution.
Caution!
Damage to the appliance/fabrics
If the end of the drain hose is
immersed in the drained water, water
may be sucked back into the
appliance and may damage the
appliance/fabrics.
Make sure that:
– The plug does not block drainage
from the sink.
– The end of the drain hose is not
immersed in the drained water.
en
29