Operation; Switching On - Pelgrim GVW445ONY Instructions For Use Manual

Hide thumbs Also See for GVW445ONY:
Table of Contents

Advertisement

Available languages

Available languages

OPERATION

Switching on

GB 8
2 3 4
• Open the door to the dishwasher.
• Press the "on/off" button (1) to switch on the appliance.
The indicator will light up when the appliance is switched on.
• Select the desired cycle (see page 9 and 10 "cycle selection table").
Press the programming button (7) repeatedly to select the required
cycle. The indicator (6) corresponding to the selected cycle will
light up.
• Close the door to the dishwasher. The dishwasher will automatically
start running the selected cycle.
Delayed start
If you want the dishwasher to switch on at a later time, you can used
the "delayed start" button (4). Each press on the button delays the start
by 1 hour. You can read the delayed start time on the display. You can
delay the start time by up to a maximum of 24 hours.
Selecting a half load
Press the "half load" button (8) to activate the half load cycle. The lower
spray arm is switched off during the half load cycle. This means that
you should only load the upper basket.
Stopping or changing a wash cycle
Open the door. Press and hold the programming button (7) for more
than 3 seconds. You can now re-select the desired cycle (see page 9
and 10 "cycle selection table"). Now close the door.
Note! A cycle that has already begun can only be changed in the start-
up phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Dishwasher
detergent).
8
5
7
6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gvw445ony/p01

Table of Contents