Operation; Switching On - Pelgrim GVW475ONY Instructions For Use Manual

OPERATION

Switching on

GB 8
2 3
6
2 3 7
• Open the door to the dishwasher.
• Press the "on/off" button (1) to switch on the appliance.
The indicator will light up when the appliance is switched on.
• Select the desired cycle (see page 9 and 10 "cycle selection
table"). Press the programming button (5) repeatedly to select the
required cycle. The indicator (4) corresponding to the selected cycle will
light up.
• Close the door to the dishwasher. The dishwasher will automatically
start running the selected cycle.
Delayed start time (only model GVW475ONY)
If you want the dishwasher to switch on at a later time, you can used
the "delayed start" button (6). You can choose to delay the start time by
3, 6, 9 or 12 hours. Each press of the button (6) changes the delay time.
The indicators (6) show the delayed start time that has been selected.
Select half load (only model GVW475ONY)
Press the "half load" button (7) to activate the half load cycle. The lower
spray arm is switched off during the half load cycle. This means that
you should only load the upper basket.
Stopping or changing a wash cycle
Open the door. Press and hold the programming button (5) for more
than 3 seconds. You can now re-select the desired cycle (see page 9
and 10 "cycle selection table"). Now close the door.
Note! A cycle that has already begun can only be changed in the start-
up phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Detergent
compartment).
GVW465ONY
4 5
GVW475ONY
4
5