Advertisement
Available languages
Available languages
CU-50 USB Condenser Microphone
Item no. 31 21 70
1.
Intended use
This microphone converts acoustic signals (sound waves) to electric
productions, multimedia presentations and other applications such as rehearsal recordings.
The microphone is intended to be used in dry indoor locations only.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use can
cause hazards such as short circuiting, fire, electric shock etc. Read the instructions carefully and keep them.
Make this product available to third parties only together with its operating instructions.
2.
Delivery content
•
Microphone
•
USB cable (2.9 m)
•
Holder
•
Stand
•
Case
•
Operating instructions
3.
Safety instructions
Read the operating instructions carefully and especially observe the safety information. If
you do not follow the safety instructions and information on proper handling in this manual,
we assume no liability for any resulting personal injury or damage to property. Such cases
will invalidate the warranty/guarantee.
Persons / Product
•
Do not turn the microphone towards the loudspeakers. This results in acoustic feedback which can damage
both loudspeakers and microphone.
•
The device is not a toy. Keep it out of the reach of children and pets.
•
Do not leave packaging material lying around carelessly. These may become dangerous playing material
for children.
•
Protect the product from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture,
flammable gases, vapours and solvents.
•
Do not place the product under any mechanical stress.
•
If it is no longer possible to operate the product safely, take it out of operation and protect it from any
accidental use. Safe operation can no longer be guaranteed if the product:
-
is visibly damaged,
-
is no longer working properly,
-
has been stored for extended periods in poor ambient conditions or
-
has been subjected to any serious transport-related stresses.
•
Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the
product.
•
Also observe the safety and operating instructions of any other devices which are connected to the
product.
Miscellaneous
•
Consult an expert when in doubt about operation, safety or connection of the device.
•
Maintenance, modifications and repairs are to be performed exclusively by an expert or at a qualified
shop.
•
If you have questions which remain unanswered by these operating instructions, contact our technical
support service or other technical personnel.
4.
Operation
Assembly
1.
Screw the holder onto the stand.
2.
Slide the microphone into the holder.
3.
Swing the legs of the stand fully out and place it on an even, clean surface.
4.
You can tilt the microphone as required.
Audio recording
1.
Lower the volume on your computer.
2.
Connect the USB cable to the microphone.
3.
Connect the USB plug to a free USB port on your laptop computer.
4.
If required, set the product as an audio input device on your computer.
5.
Run suitable software for audio recording.
6.
Control the volume via the computer the microphone is connected to.
7.
After use, disconnect the product from the computer.
5.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory
regulations.
Version 05/12
signals. The product is suitable for podcast
6.
Technical data
Current consumption:
32 mA +/-10 %
System requirements:
Windows® 2000 / XP / Vista™ (32/64 Bit) / 7 (32/64 Bit)
Directional characteristic:
Unidirectional
Max. SPL:
135 dB
Impedance:
100 Ω
Frequency response:
20 – 20000 Hz
Sensitivity:
-35 dB ±2 dB
Dim. (Ø x L):
21 x 184 mm
Weight:
91 g (microphone)
Frequency response
Directional characteristic
These operating instructions are published by Conrad Electronic SE,
Klaus-Conrad-Straße 1, D-92240 Hirschau/Germany.
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
The operating instructions reflect the current technical specifications at time of print.
We reserve the right to change the technical or physical specifications.
© 2012 by Conrad Electronic SE.
V2_0512_02-JU
Advertisement
