Advertisement
IR Touch Overlay
Installation Guide for the OLR-861
6.0 Installation Procedure
6.1 Remove the overlay from the packaging. Place the overlay face down on a padded surface and verify
the material contents (see Equipment on Page 2).
6.2 Use a #2 Philips screwdriver to remove the five (5) #6-32 flathead screws securing the bottom
bracket to the overlay.
6.2.1 Do NOT remove any remaining screws from the overlay.
6.3 Remove the bottom bracket from the overlay.
6.3.1 Set the screws and bracket aside for reuse in steps 6.9 and 6.10.
6.4 Use a cloth and mild cleaner to clean the monitor and inside surface of the overlay.
6.4.1 Do not use any chemical solvents, such as acidic or alkali solutions.
6.4.2 If available, use compressed air after cleaning to remove any lint or dust.
www.necdisplay.com
NEC Display Solutions of America, Inc.
OLR-861
Rev 1.0
3
Advertisement
