Table of Contents
Advertisement
4. Fit and adjust the side handle (C).
5. Turn the tool on and start working.
6. Always turn the tool off when work is finished and before unplugging.
MAINTENANCE
WARNING: Shock Hazard. To reduce the risk of serious personal injury, turn
tool off and disconnect from power source before making any adjustments or
removing/installing attachments or accessories.
Brushes (Fig. 3)
The carbon brushes are not user-serviceable. Take the tool to an authorized D
repair agent.
The yellow brushwear indicator LED (R) lights up when the carbon brushes are nearly
worn out. After a further 8 hours of use or after the brushes have completely worn
out the motor will automatically be shut offf.
Tool maintenance needs to be carried out as soon as the service indicator (S) lights up.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a
week. To minimize the risk of eye injury, always wear AS/NZS standard approved eye
protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never let
any liquid get inside the tool; never immerse any part of the tool into a liquid.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING: Since accessories, other than those offered by D
tested with this product, use of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
with this product.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory,
please contact D
WALT Industrial Tool Co., 20 Fletcher Road, Mooroolbark, VIC 3138
E
Australia or call 1800 654 155 or (NZ) 0800 339258.
WALT
E
Concrete
RPM
No load BPM
Guarantee
Applicable to hand held Power Tools, Lasers and Nailers.
Three Year Limited Warranty
D
WALT will repair, without charge, any defects due to faulty materials or
E
workmanship for three years from the date of purchase. Please return the complete
unit, transportation prepaid, to any D
service station.
For warranty repair information, call (AUS) 1800 654 155 or (NZ) 0800 339258.
This warranty does not apply to
• Accessories
• Damage caused where repairs have been made or attempted by others.
• Damage due to misuse, neglect, wear and tear, alteration or modification.
This warranty gives you specific legal rights and you may have other rights under the
provisions of the Consumer Guarantee Act 1993 (New Zealand only), Trade Practices
Act 1974 and State Legislation (Australia only).
9
WALT, have not been
E
WALT, recommended accessories should be used
E
MAXIMUM CAPACITY
D25712-XE
48 mm (1-7/8")
137–275
1260–2520
WALT Service Centre, or any authorised
E
Advertisement
Table of Contents
