Pelgrim PWD112WIT Detailed Instructions page 42

Problem/error
The dryer does not work.
There is voltage in the
outlet, but the drum
does not spin and the
dryer does not work.
Laundry is not dried, or
drying temperature is
longer than 4h.
Unevenly dried laundry.
Error in the drum
lighting.
On display: F3
On display:F4
On display:"LO"
Write down the failure/error code: F0, F1, or F2, disconnect the appliance and call the
nearest authorized service (call center).
42
Cause
• No voltage in the power
outlet
• Program was not started
in accordance with the
instructions.
• The door is not properly
closed.
• Condensate tank is full.
• Delayed start function has
been selected.
• Filters are not clean. The
room is not sufficiently
ventilated.
• Inappropriate temperature
in the room
• Laundry was not sufficiently
wrung or spun.
• Amount of laundry dried in
the appliance is too large or
insufficient.
• The amount of laundry
dried at a time is too large.
• Drying the pieces of
different thicknesses
• Drying the different types
of laundry
• There is no lighting when
the dryer door is opened.
• Full condensate tank
• If the condensate tank is
empty, there is a pump
failure.
• Clogged filters
• If the filters are clean,
there may be a compressor
failure.
• Steam generator tank is
empty
What to do ...?
• Check if the power cord plug
is correctly inserted into the
power outlet.
• Check the fuse.
• Reread the instructions for use
again.
• Push the door towards the
appliance.
• Empty the condensate tank
(see section Cleaning and
Maintenance).
• Wait until the time indicated on
the display elapses.
• Clean the filters.
• Install the dryer in an
appropriate room (see section
Installation ...)
• Check if the temperature in
the room where the dryer is
installed is too high (over 25°C)
or too low (below 10°C).
• Laundry inserted into the dryer
was not sufficiently wrung or
spun, or an inappropriate drying
program was selected.
• Use an appropriate program or
use the timed program. Increase
the final level of dryness for the
selected program (intensive
drying function).
• Make sure the laundry is sorted
by type and size of items given
the selected program (see
section Drying – Preparing
the Laundry and the Program
Table).
• Disconnect the dryer from
the power mains and call an
authorized service unit.
• Empty the condensate tank
(see section Cleaning and
Maintenance).
• Disconnect the appliance and
call the nearest service unit.
• Clean the filters.
• Disconnect the appliance and
call the nearest service unit.
• Add distilled water