Functional Description - Makita BO5030 Instruction Manual

WARNING: DO NOT let comfort or famil-
iarity with product (gained from repeated
use) replace strict adherence to safety
rules for the subject product. MISUSE or
failure to follow the safety rules stated in
this instruction manual may cause serious
personal injury.
FUNCTIONAL
DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function
on the tool.
Switch action
► Fig.1: 1. Switch
CAUTION:
• Before plugging in the tool, always be sure that
the tool is switched off.
To start the tool, press the "I (ON)" side of the switch. To
stop, press the "O (OFF)" side of the switch.
Speed adjusting dial
For Model BO5031
► Fig.2: 1. Speed adjusting dial
The tool speed can be infinitely adjusted between 4,000
and 12,000 orbit per minute by turning the adjusting
dial. Higher speed is obtained when the dial is turned in
the direction of number 5; lower speed is obtained when
it is turned in the direction of number 1.
Refer to the figure for the relationship between the num-
ber settings on the adjusting dial and the kind of work.
A range: For polishing
B range: For finish sanding
C range: For regular sanding
12,000
4,000
A
1
2
NOTE:
• The figure shows standard applications. They
may differ under certain conditions.
C
B
3 4
Dial setting
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing abrasive disc
► Fig.3
To install the abrasive disc, first remove all dirt or for-
eign matter from the pad. Then peel off the backing
paper from the abrasive disc and attach the abrasive
disc to the pad. Be careful to align the holes in the
abrasive disc with those in the pad.
CAUTION:
• If you peel off the abrasive disc from the pad,
its adhesion will become poor. Never attempt to
stick it onto the pad for further use.
Installing dust bag
► Fig.4: 1. Dust bag
Install the dust bag on the tool so that the Makita logo
on the dust bag will be upright (not upside down).
Emptying dust bag
► Fig.5: 1. Dust nozzle
When the dust bag is about half full, switch off and
unplug the tool. Remove the dust bag from the tool.
Then remove the dust nozzle from the dust bag after
unlocking the dust nozzle by turning it slightly counter-
clockwise. Empty the dust bag by tapping it lightly.
After emptying the dust bag, install the dust nozzle on
the dust bag. Turn the dust nozzle slightly clockwise to
lock it in place. Then install the dust bag on the tool as
described in "Installing dust bag".
► Fig.6: 1. Dust nozzle
Installing paper dust bag
► Fig.7: 1. Groove 2. Front fixing cardboard 3. Front
side of paper dust bag
Place the paper dust bag on the paper dust bag holder
with its front side upward. Insert the front fixing card-
board of the paper dust bag into the groove of the paper
dust bag holder.
Then press the upper part of the front fixing cardboard
in arrow direction to hook it onto the claws.
► Fig.8: 1. Claws 2. Upper part
Insert the notch of the paper dust bag into the guide of
the paper dust bag holder. Then install the paper dust
bag holder set on the tool.
► Fig.9: 1. Notch 2. Guide
► Fig.10
5
5 ENGLISH