Using The Kensington Security System; Mounting On A Wall; Separate Purchase (Wall Mounting Bracket) - LG 32MN49HM-PT.ATI Owner's Manual

Using the kensington security system

(This is not available for all models.)
• Image shown may differ from your monitor.
The Kensington security system connector is located at the rear of the
monitor. For more information of installation and using, refer to the
manual provided with the Kensington security system or visit http://
www.kensington.com.
Connect the Kensington security system cable between the monitor
and a table.
NOTE
• The Kensington security system is optional. You can obtain additional
accessories from most electronics stores.

Mounting on a wall

Install the monitor at least 10 cm away from the wall and leave about 10
cm of space at each side of the monitor to ensure sufficient ventilation.
Detailed installation instructions can be obtained from your local retail
store. Alternatively, please refer to the manual for how to install and set
up a tilting wall mounting bracket.
10 cm
To install the monitor to a wall, attach a wall mounting bracket
(optional) to the back of the monitor. Make sure that the wall mounting
bracket is securely fixed to the monitor and to the wall.
1 If you use screws longer than the standard length, it may damage
the inside of the product.
2 A non-VESA standard screw may damage the product and cause the
monitor to fall. LG Electronics is not liable for any accidents relating
to the use of non-standard screws.
8
10 cm
10 cm
10 cm
Separate purchase (Wall mounting
bracket)
Model
Wall Mount
A
(A x B) (mm)
B
Standard screw
Number of screws
Wall mount bracket
(optional)
CAUTION
• Disconnect the power cord first, and then move or install the monitor.
Otherwise electric shock may occur.
• If you install the monitor on a ceiling or slanted wall, it may fall and
result in severe injury. Use an authorized LG wall mount and contact
the local dealer or qualified personnel.
• Do not over tighten the screws as this may cause damage to the
monitor and void your warranty.
• Use the screws and wall mounts that meet the VESA standard. Any
damages or injuries by misuse or using an improper accessory are not
covered by the manufacturer's warranty.
• Screw length from outer surface of back cover should be under 8 mm.
Wall mount plate
Wall mount plate
Guide spacer fix
screw
NOTE
• Use the screws that are listed on the VESA standard screw
specifications.
• The wall mount kit includes an installation manual and necessary
parts.
• The wall mount bracket is not provided. You can obtain additional
accessories from your local dealer.
• The length of screws may differ depending on the wall mount. Make
sure to use the proper length.
• For more information, refer to the manual supplied with the wall
mount.
32MN49HM
200 x 200
M6
4
LSW240B
Back of the monitor
Guide spacer