Table of Contents
Advertisement
Control Function Guide
Function
ON/OFF
Adjust Temperature
Toggle Between o F / o C
Leave Interior Light On
Enable Sabbath Mode
Disable Sabbath Mode
Door Alert Notification
When the door is left open for more than 5 minutes:
•
will appear in display
•
Close door to reset
USING YOUR ELECTRONIC CONTROL
Electronic control
Command
Press
and hold for 5 seconds.
Press
or
and release.
Hold
and
for 5 seconds.
Press
and release to leave interior light on for
12 hours; press again to deactivate.
Press
and hold for 5 seconds and release.
Press
and release.
Figure 10
Notes
Unit will immediately turn ON or OFF.
When the display is flashing, press
point temperature. Note: temperature displayed is the actual
temperature inside unit.
The display will change units.
After 12 hours, factory default is restored; light will turn on when
door is open.
The o F / o C symbol will flash briefly after 5 seconds. Interior
light and display will go dark and remain so until user resets
mode - unit continues to operate.
Display and interior light return to normal operation.
NOTE
Temperature displayed reflects actual temperature inside unit. If the
temperature displayed is different than selected, the unit is progressing
towards the selected temperature. Time to reach set point varies based
upon ambient temperature, temperature of product loaded, door
openings, etc. DCS recommends allowing the unit to reach set points
before loading.
10
or
to adjust the set
Advertisement
Table of Contents
