Technical Data - AEG IKE64471FB User Manual

Problem
and a number come on.
9.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre. Give the data
from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the
corner of the glass surface) and an error

10. TECHNICAL DATA

10.1 Rating plate
Model IKE64471FB
Typ 62 B4A 05 AA
Induction 7.35 kW
Ser.Nr. .................
AEG
10.2 Cooking zones specification
Cooking zone Nominal power
(maximum heat
setting) [W]
Right front 1400
Possible cause
The diameter of the bottom of the
cookware is too small for the zone.
FlexiBridge (Flexible Bridge) oper‐
ates. One or more sections of the
function mode which operates are
not covered by the cookware.
PowerSlide operates. Two pots are
placed on the flexible induction
cooking area or the cookware covers
more than one cooking area activa‐
ted by the function.
There is an error in the hob.
message that comes on. Make sure, you
operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The information about
guarantee period and Authorised Service
Centres are in the guarantee booklet.
PNC 949 597 627 00
220 - 240 V / 400 V 2N 50 - 60 Hz
Made in Germany
7.35 kW
PowerBoost [W]
2500
Remedy
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Place the cookware on the correct
number of sections of the function
mode which operates or change the
function mode. Refer to "Flexible in‐
duction cooking area".
Use only one pot. Refer to "Flexible in‐
duction cooking area".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
PowerBoost maxi‐ Cookware diame‐
mum duration ter [mm]
[min]
4 125 - 145
comes
ENGLISH 43