Advertisement
ASSEMBLY INSTRUCTIONS
• The heater is packaged with the feet unattached. You must attach them before operating the heater.
WARNING: Do not operate without feet attached. Only operate the heater in an upright position (feet on the bottom, controls
on the top), any other position could create a hazardous situation.
1. Place the radiator body upside-down on a scratch-free location, make sure it is stable and will not fall.
2. R emovethewingnutsfromtheU-boltprovided(seeFig1),inserttheU-shapedboltaroundtheflangebetweenfirstpairof
fins(nearthefrontcover)(seeFig2).
3. I nsertthethreadedendsoftheUboltthroughtheholesonthecastormountingplate(seeFig3).
4.ScrewthewingnutsbackontotheUboltandtighten(seeFig4).
5.RepeatwiththerearcastorinsertingtheU-boltbetweenrearmostpairoffins
Note:donotover-tighten,asthismaycausethedamageofradiatorflange.
INSTRUCTIONS FOR USE
• B eforeusingtheheater,makesurethatitisonaflatandstablesurface.Damagemayoccurifitisplacedonaninclineor
uneven surface.
• Set all the controls to OFF position and insert the plug into a mains socket
• Set the timer by turning the dial clockwise (do not turn it counter clockwise) until the pointer arrow aligns to the correct
time. Mains power is required to keep the clock running.
• RotatethethermostatknobclockwisetoMAXpositionandswitchtheheateron.
• Switch I is for low heat, switch II for medium heat and turn both switches on for high heat. When the heating element is on
the power switch will illuminate.
• When your room reaches the desired temperature, slowly rotate the thermostat control counter clockwise until the power
light goes out. The thermostat can now be left at this setting. As soon as the room temperature has dropped below the set
temperature, the unit will switch it self on automatically until the set temperature has been reached again. In this way the
room temperature remains constant with the most economical use of electricity.
• If you want to change the room temperature setting, rotate the thermostat knob clockwise to raise the temperature, or
counter clockwise to lower it.
USING THE TIMER
• The timer has a small red switch, the function is as follows: I=Heater is under manual control or
• Set the timer to
position. There are 96 small plastic pins around the timer, each correspond to 15 minutes interval.
• When the pins are set outward the heater will be ON and when set inwards the heater will be turned OFF.
CAUTION: Do not use the timer function unattended.
• The heater will not operate if timer if set to the
set too low.
Newark.com/exclusive-brands
Farnell.com/exclusive-brands
Element14.com/exclusive-brands
position but the pins have not been set accordingly or the thermostat is
Page <3>
=Timer function is ON.
18/08/20
V1.0
Advertisement
