DeWalt DCHJ064 Instruction Manual page 12

USB Charging Ports (Fig. 2, 5)
The DCB091 USB power source (C) is equipped with two USB
Type A charging ports (G). The DCB091 USB power source delivers
1.5 amps total current.
NOTE: Do not plug in devices that exceed the output ratings
on the power source's label. Doing so will shorten the power
source's useful life.
Insert a USB plug into one of the charging ports (G) to supply power
or charge your device when battery is installed.
Make sure that all cables, USB cables or others, remain
NOTICE:
coiled in the pocket, as shown in figure 5, when charging a USB
device so that it will not be stepped on, tripped over or otherwise
subjected to damage or stress.
FIG. 5
G
CLEANING
WARNING: To reduce the risk of personal injury or damage to
the heated jacket ALWAYS disconnect the power jack from the
DCB091 USB power source and remove the battery pack and
DCB091 USB power source from the battery/power source
pocket before performing any maintenance or washing.
Follow the CARE label attached to the heated jacket.
NOTICE:
• WASH AND DRY ACCORDING TO THE GARMENT CARE
TAG
• Use a commercial liquid soap product. Do not use fabric
softeners, biological powders or strong detergents.
• DO NOT dry clean. DO NOT use bleach. Cleaning
solvents may damage or lessen the effect of the jacket's
insulated heating element.
• DO NOT iron or press.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
Repairs
The charger, battery pack, DCB091 USB power source and jacket
are not serviceable.
10