Page 1
I N S T A L L A T I O N I N S T R U C T I O N S Instrucciones de instalación Istruzioni di installazione Installationsanleitung Installatie-instructies Instruções de Instalação Instructions d´installation Mount, Dual Monitor, Column, Space Saver Spanish Product Description German Product Description Portuguese Product Description Italian Product Description Dutch Product Description French Product Description LLR03187...
ACCESSORY: AN ACCESSORY is the secondary Lorell Allowed for EACH Capacity of Mount product which is attached to a primary Lorell product, and may Display have a component attached or setting on it. COMPONENT: A COMPONENT is an audiovisual item...
Page 3
Installation Instructions LLR03187 DIMENSIONS FULL UP/DOWN = MIN RANGE HEIGHT ADJUST RANGE DESKTOP THICKNESS DIMENSIONS: INCHES [MILLIMETERS]...
Page 4
LLR03187 Installation Instructions LEGEND Tighten Fastener Pencil Mark Apretar elemento de fijación Marcar con lápiz Befestigungsteil festziehen Stiftmarkierung Apertar fixador Marcar com lápis Serrare il fissaggio Segno a matita Bevestiging vastdraaien Potloodmerkteken Serrez les fixations Marquage au crayon Loosen Fastener Drill Hole Aflojar elemento de fijación...
Installation Instructions LLR03187 TOOLS REQUIRED FOR INSTALLATION 3/16” (included) 1/8” (included) PARTS A (1) [Desk clamp assembly] Display Mounting Hardware Kit D (8) B (8) E (2) C (8) F (2) M10x5.3xM10 M4x10mm M4x20mm #10-32 x 3/8" M4 x 4mm...
LLR03187 Installation Instructions ASSEMBLY AND INSTALLATION Grommet Hole Option NOTE: The clamp mounts may be installed directly to grommet Connecting Desk Clamp Arms to Desk holes between 1 1/4” and 2 1/2” in diameter. If grommet Standard Installation to Desk Edge hardware (G, H, J) is used, they can be installed to grommet holes between 3/8”...
It is the installer’s responsibility to make sure the combined weight of all components attached to the LLR03187 Monitor Arm and Figure 5 the desk up to (and including) the display does not exceed Locate a flat surface (thickness of 3/4”...
Page 8
LLR03187 Installation Instructions Carefully place display face down on protective surface. Connect faceplate to display For flush mounting hole installation: • Using Phillips screwdriver, carefully install four M4x10mm screws (B) through corresponding holes on faceplate and into the mounting holes on the display.
Installation Instructions LLR03187 Adjustments Pitch Adjustment Low Profile Adjustment Adjust pitch to desired tilt position. (See Figure 13) Adjust arm to achieve desired low profile depth. (See Adjust pitch tension screw to change the adjustment Figure 11) tension. (See Figure 13) Use 1/8"...
LLR03187 Installation Instructions Lift Arm Tension Adjustment Display Removal Security Screw Tension may be adjusted with tension adjustment screw NOTE: In order to prevent display from being easily removed inside cable management cover and 1/8” hex key (L). Turn from mount using the quick release lever, install...
Installation Instructions LLR03187 Cable Management (OPTIONAL) Route through cable clip on column. (See Figure 21) Press insides of cable management covers at both ends to unhinge tabs on either end of cable management cover on upper arm. (See Figure ) Lift cable management cover up until tabs are unhinged and cover is in the “open”...