Buffalo WLAR-L11-L Install Manual page 2

Package Details and Parts Nomenclature and Functions
5
POWER lamp
ON(Green): Power is on.
OFF: Power is off.
WIRELESS lamp
ON(Green): Wireless LAN connection is active.
Flashing(Green): Communicating with the
wireless LAN.
WAN lamp
ON(Green): 10Base-T Linking.
Flashing(Green): Communication is active.
DIAG lamp
ON(Red): Error has occurred (See note) or
Initializing or Writing the flash memory.
OFF: No error
Note: The type of error can be identified by
the number of times the DIAG lamp
flashes. Refer to Chapter 4 Self-
Diagnostic Function in the separate
Reference Manual for details.
Factory setting switch
Press this switch to reset the
AirStation to the factory setting.
10M/100M
Connect to the PC and hub.
WAN port
Connect to the cable modem
and hub.
DC connector
Connect to the enclosed AC adapter.
X1
X2
ON(Green):
Each 10M/100M port is linking.
X3
Flashing(Green):
X4 Each 10M/100M port is
Communicating.
DIAG
ON(Red): Error has occurred
Flashing(Red): Writing the flash memory
Side panel
Front panel
MAC address(LAN side)
Displays the AirStation MAC address(LAN side).
12 digit number starting from "00
40 26".
MAC address(WAN side)
Displays the AirStation MAC address(WAN side).
12 digit number starting from "00
40 26".
Removing the rear cover
Remove the rear cover by
Rear panel
gently squeezing both
sides, and then pulling
the cover towards you.
Pull
.
Radio Frequency Precautions
Do not install or use the AirStation in the following locations.
Close to microwave ovens, or in locations where static electricity or electrical interference may occur (the radio frequency may be jammed in some
environments).
Note: Using the AirStation near a wireless printer buffer or other device using frequencies near 2.4 GHz may result in reduction of baud
rate for both devices.
Push
WLAR-L11-L Installation Manual 1 November, 2000 First revision TECHWORKS INC./BUFFALO TECHNOLOGY.