Chamberlain PIRV400R User Manual

Overview
The PIR Motion Sensor only works with
Chamberlain's Wireless Pedestrian & Vehicle Alert
with Voice (Model RWV400R) and Office Alert
(Model CWV1000). The PIR Motion Sensor can be
used to monitor motion up to 30' away and can
transmit a signal up to 1000' away from the Base
Station (not included). The Passive Infra-Red sensor
detects movement of people and vehicles, while
allowing small animals to pass through undetected.
The PIR Motion Sensor has a built-in microphone and
speaker that allows for communication between the
Base Station and the Sensor. When the PIR Motion
Sensor detects movement a signal is sent to the base
station which alerts the homeowner with sounds and
lights. The Alert can also remotely control a low
voltage electrical device near the PIR Motion Sensor
like a light or a camera (See Advanced Features).

Carton Inventory

Swivel Bushing
Mounting Plate
Passive Infra-Red (PIR)
Operation & Features
PIR Motion
Sensor
PIR Sensor/Test Light
Speaker
On/Off: To turn Base Station OFF hold down the
Volume button until a beep is heard and light goes
out. To turn Base Station ON press the Talk button.
Motion Sensor
Base Station
(not provided)
Volume Button
Talk
(Power - On)
Relay Output
Remote
Contacts
Activation
Button
AC Adapter
Learn
Switch #1: Mute
Button
Switch #2: Tone
®
Wireless Pedestrian & Vehicle Sensor with Voice
Wireless Office Alert Add-On Sensor
To prevent possible SERIOUS INJURY or DEATH from
electrocution, outputs are suitable ONLY for controlling low
voltage devices, 24V max, ac or dc.
Intercom Feature: When PIR Motion Sensor has
detected motion, the Base Station will allow you to
listen through the PIR Motion Sensor for 10 seconds.
If you wish to talk to the person on the other end,
hold down the Talk button and speak, releasing it to
hear.
Volume: Pressing the Volume button repeatedly will
cycle through volume levels.
Mute: To temporarily mute Base Station, hold the
Volume and Talk buttons down for three seconds.
The Base Station will reactivate after one hour, or by
pressing the Talk button.
Remote Button: If there is an accessory device
connected to the relay on the PIR Motion Sensor, it
can be activated by pressing the Remote button
within 30 seconds of the signal from the alert buzzer.
Switch #1:
OFF Buzzer Off
ON Buzzer On (Default)
Switch #2:
OFF Long Buzz
ON Short Buzz (Default)
Battery: The AA Alkaline batteries (not provided) will
last up to 2 years depending on use (Lithium batteries
recommended for colder environments). If PIR Motion
Sensor batteries are low Base Station will emit three
high-pitch beeps every ten minutes. If Base Station
batteries are low it will emit two high-pitch beeps.
Clear Memory: Press and hold the Learn button on
the Base Station until 3 beeps are heard. If the PIR
Motion Sensor signals while Learn button is pressed,
repeat the procedure.
Programming Additional PIR Motion Sensors:
Each Base Station can learn the code of up to 8 PIR
Motion Sensors, responding with multiple buzzes. To
program additional PIR Motion Sensors see Step 6.
1
Models PIRV400R
AOSV
1 2
OFF
ON