Table of Contents
Advertisement
Installation Notices for the M.2 and SATA Connectors:
Due to the limited number of lanes provided by the Chipset, the availability of the SATA connectors may be
affected by the type of devices installed in the M2A_32G connector. The M2A_32G connector shares bandwidth
with the SATA3 0 connector. Refer to the following table for details.
Connector
SATA3 0
Type of M.2
SSD Installed
M.2 SATA SSD
r
M.2 PCIe x4 SSD
a
M.2 PCIe x2 SSD
a
No M.2 SSDs Installed
a
a: Available, r: Not available.
8) F_PANEL (Front Panel Header)
Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status indicator
on the chassis to this header according to the pin assignments below. Note the positive and negative pins
before connecting the cables.
Power LED
Power Switch
Speaker
2
1
Hard Drive
Reset
Power LED
Activity LED
Switch
Chassis Intrusion
Header
• HD (Hard Drive Activity LED, Blue):
Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive
is reading or writing data.
• RES (Reset Switch, Green):
Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer
if the computer freezes and fails to perform a normal restart.
• CI (Chassis Intrusion Header, Gray):
Connects to the chassis intrusion switch/sensor on the chassis that can detect if the chassis cover has
been removed. This function requires a chassis with a chassis intrusion switch/sensor.
• NC (Orange): No Connection.
The front panel design may differ by chassis. A front panel module mainly consists of power switch,
reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis
front panel module to this header, make sure the wire assignments and the pin assignments are
matched correctly.
SATA3 1
SATA3 2
SATA3 3
a
a
a
a
a
a
a
a
a
a
a
a
• PLED/PWR_LED (Power LED, Yellow/Purple):
System Status LED
S0
On
S3/S4/S5
Off
20
• PW (Power Switch, Red):
19
Connects to the power switch on the chassis front panel. You may
configure the way to turn off your system using the power switch (refer
to Chapter 2, "BIOS Setup," "Power," for more information).
• SPEAK (Speaker, Orange):
Connects to the speaker on the chassis front panel. The system reports
system startup status by issuing a beep code. One single short beep
will be heard if no problem is detected at system startup.
- 16 -
SATA3 4
SATA3 5
a
a
a
a
a
a
a
a
Connects to the power status indicator
on the chassis front panel. The LED is on
when the system is operating. The LED is
off when the system is in S3/S4 sleep state
or powered off (S5).
Advertisement
Table of Contents
