Installation; Hardware Installation - BenQ FP2081 User Manual

Installation

Hardware Installation

A. Make sure that the computer and monitor's power are both turned off. Please follow
the steps to install your LCD monitor.
1 . Connect the signal cable and power adaptor to Benq LCD monitor.
2 . Please connect power cord to power adaptor first and then connect the power adap-
tor to LCD monitor.
B. Connect the signal cable to the VGA output of the graphics card on the computer.
There are 4 types of signal cables:
a. D-Sub (included and attached)
b. DVI-D (included but not attached)
c. S-Video (not included)
d. Composite (not included)
Note: If you are using AV connector, please connect Video output of device to Composite
port of FP2081.
C. Connect the power cord at the back of the monitor to an AC power socket. Please
make sure that the socket is not blocked or covered, so you can disconnect the unit
from AC supply if you need to. Your monitor is equipped with an automatic power sup-
ply for a voltage range from 100 to 240 Volt at a frequency of 50 to 60 Hz. Be sure that
your local power is within the supported range. If you are unsure, ask your electricity
supplier.
Benq LCD Color Monitor User's Guide
English 6