Fasten The Rail To The Motor Unit And Install The Trolley - Chamberlain POWER DRIVE PD432D 1/2 HP Owner's Manual

1/2hp garage door opener
Table of Contents

Advertisement

ASSEMBLY STEP 2
Fasten the Rail to the Motor Unit and
Install the Trolley
NOTE: To aid in assembly and installation, replace the
foam packing around the motor unit. Remove it after
Installation Step 4.
1. Working on a level surface, align the rail assembly with
the motor unit, as shown.
2. Slip the coupling over the rail sprocket.
3. Slide the rail through the motor unit bracket until the
coupling fits securely over the motor unit sprocket.
4. Align the four bolt holes in the rail with those in the
motor unit bracket. Insert four 1/4"-20x7/16" hex bolts.
Tighten securely with a 3/8" socket wrench.
5. Disengage trolley by turning the release arm down
(arrow pointing up). Slide trolley onto and along the
bottom of the rail until it aligns with the rack. Turn
release arm up (arrow pointing away from motor unit.
This will join the rack and the trolley.
Rail
Assembly
Release arm
Hex Bolts
1/4-20x7/16"
Coupling
Rail
Sprocket
Foam Packaging
Arrow must point up
10
HARDWARE SHOWN ACTUAL SIZE
Hex bolt 1/4-20x7/16"
Motor Unit
Motor Unit
Bracket
Sprocket
Rack
Trolley
To the motor unit
Hex Bolts
1/4-20x7/16"

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Power drive pd432d

Table of Contents