, AFTER EACH USE
•
Ensure the beard trimmer is switched off and disconnected from the mains
before cleaning.
•
Brush the accumulated hair from the blades.
•
To clean unit, wipe with a damp cloth and dry immediately.
•
Do not submerge the clipper in water.
•
Remove vacuum chamber from unit, empty chamber and rinse under
running tap.
, WASHABLE ATTACHMENT HEADS
•
The washable attachment heads are designed to ensure easy maintenance
of your beard and grooming kit
•
Ensure each of the attachment heads are removed from the beard trimmer.
•
Wash the heads under a running tap to remove any hair clippings. Do not
run the entire unit under the tap.
•
Once dry, place desired attachment head on top of the unit.
, Note: Ensure the clipper is turned off when cleaning.
BATTERY REMOVAL
•
The battery must be removed from the appliance before it is scrapped.
•
The appliance must be disconnected from the supply mains when removing
the battery.
•
Ensure that the clipper is discharged of all power and disconnected from the
mains
•
Lift or pry the top housing and remove the top housing.
•
Unscrew the 2 screws located on the printed circuit board assembly.
•
Lift or pry the clipper halves apart, exposing the battery chamber.
•
Take out the battery and printed circuit board assembly from the battery
chamber.
•
Cut the tabs on both ends of the battery and remove it from the printed
circuit board
•
The battery is to be disposed of safely.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances marked with this
symbol must not be disposed of with unsorted municipal waste, but
recovered, reused or recycled.
8