Selecting Multis - Kurzweil PC4-7 Getting Started Manual

PC4 Sounds

Selecting Multis

In Multi Mode, use any of the methods below to select a Multi.
Browse All Multis
Make sure the USER button is off, then use the Alpha Wheel or PREVIOUS and NEXT
buttons to select a Multi from all of the available Multis.
Select a Multi by ID Number
Use the CATEGORY buttons to type an ID number followed by pressing the ENTER
button.
Select a Previously Saved User Multi
Press and turn on the USER button, then use the Alpha Wheel or PREVIOUS and NEXT
buttons to browse only User Multis. To return to browsing Factory and User Multis, press
and turn off the USER button.
VIEW Soft Button and Quick Access View
In Program or Multi Mode, press the VIEW soft button to switch between the default Large
view, List view, and Quick Access view.
Quick Access view shows the names of 10 favorite Programs and/or Multis, which can be
selected by pressing the corresponding numbers on the Keypad. To access more than 10
Programs/Multis, use the CHANNEL/LAYER/ZONE/TRACK buttons to select a different
Quick Access Bank. Programs or Multis which are not stored in a Quick Access Bank can be
browsed by using the ALPHA WHEEL or PREVIOUS/NEXT buttons.
When Quick Access view is selected, press and hold one of the Keypad buttons (0 through 9)
to store the currently selected Program or Multi to a spot in the current Quick Access Bank.
Controllers
The Sliders, Knobs, Buttons, Wheels, and Pedals can control each of the Factory Programs
and Multis, to produce variations to the sound. Don't forget to try these out as you explore
the Factory sounds on the PC4.
Generally, each control will perform the assignment labeled on the front panel, although
some controls may have different assignments per Program or Multi. When a controller is
moved, the name of the current assignment is shown in the display. Controller assignments
can be adjusted in Program and Multi Edit Mode.
14