Table of Contents
Advertisement
Available languages
Available languages
ENGlIsh
Fig. E
5
Switching On and Off (Fig. A)
To turn the tool on, set the on/off switch
turn the tool off, set the on/off switch
Demolition, Chasing and Channelling
(Fig. A)
WARNING: Ensure that the cutting edge does not
show discoloration caused by too much pressure. This
may impair the hardness of the accessory.
Various types of chisels are available as an option.
1. Select the appropriate chisel. Clean and grease its shank.
2. Insert the chisel and check whether it is properly locked.
3. Fit and adjust the bail/loop style auxiliary handle
make sure it is firmly tightened.
4. Hold the tool with both the main handle and the bail/
loop style auxiliary handle and switch on. The tool now
runs in continuous operation.
5. Always switch off the tool when work is finished and
before unplugging.
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Your D
WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
20
Accessories
Recommended accessories for use with your tool are
2
available at extra cost from your local dealer or authorized
service center.
Repairs
to position 1. To
1
1
to position 0.
Protecting the Environment
Products and batteries contain materials that can be
5
and
recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions.
Voltage
Power
Frequency
Impact Energy
Impact per Minute
Vibration Measurement
Weight
WARNING: Since accessories, other than those
offered by D
WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D
WALT factory service center
e
or a D
WALT authorized service center. Always use
e
identical replacement parts.
Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal household waste.
SPECIFICATIONS
D25951-B3
24 J (17.7 ft/lbs)
29 lbs (13.3 kg)
WALT
e
120V~
1600 W
50–60Hz
1620 ipm
8.8 m/s
2
Advertisement
Table of Contents
