iGGUAL PSIMS200 User Manual page 7

Table of Contents

Advertisement

Available languages

Available languages

English
3.Useful instructions
a. The screen should be switched to a suitable power supply. it can be 220V/ 50HZ,230V/ 50HZ,or 110V/ 60HZ,120V/ 60HZ,but the motor's power must be same
as the local voltage and frequency.
b. The screen can be used with or without the remote controller. The remote control system can be radio type or infrared type, normally if a remote control system
needed, a radio remote controller is supplied but an infrared type controller is also available for a special requirement these two different controlling functions can not
combined in one control system.
c. Normally a synchronized motor is installed inside the housing but a tubular motor is also available for a special requirement.
d. lf the remote control system is not accompanied, the screen can Operated by the control box directly, just push the UP/ DOWN / STOP button on the control box
and operate the screen.Or the screen can be operated by the remote controller.
e. The screen will automatically stops when the screen fabric goes up and back to the housing or when the top black border comes out totally. The screen can also
stop at any position which you want.
4. Installing
a. Unpack the screen carefully, be sure the screen is in good condition. check all the accessories are packed inside the carton.
b. Check the voltage and frequency marked on the screen is in accordance with the local power supply. It is suggested only to use the screens indoor under normal
temperature and humidity.
c. Refer to the below fig and fix the screen to the wall or to the ceiling.
d. Plug in the power supply. Press the down button of the manual switch or the transmitter,the screen will go down smoothly.Press the stop button when the screen
goes down to the expected position,otherwise the screen will stop at the lower limited position automatically.
e. Press the up button of the manual switch or the transmitter, the screen will go up Smoothly. Press the stop button when
the screen goes up to the expected position, otherwise the screen will roll back to the housing.
The screen won't be used for a long time when you cut off the power supply.
Don not pull the control wires to avoid disconnection and it's dangerous.
f. Moving Parts of the drive must be installed higher than 2,5 mm above the floor or other level that could provide access
to it.
5. Warnings
a. The screen can not be folded. Do not use fingers or hard objects to touch the screen surface Do not splash the milk fruit juice or other chemical doses to the screen
surface. Keep the screen far away from the high temperature objects or fire.
b. lf the screen is dirty. wash the screen gently by a broom or a cotton ball,do not use the organic solvents to clean the screen surface.
c. When pulling the screen down, must be slowly and vertical .Do not pull it roughly. please stop pulling as soon as the black border is out or the screen is jammed or
injured then send the screen to the maintenance center.
d. After using put the screen back to the housing in order to avoid being polluted. If not using it for a long time, please take the screen from the wall and pack it in a
carton.
e. If the power soft cable was broken, you have to replace it by technical people from the manufacturer or service department ensure safety. WARNINGS Important
safety instructions. It is important for the safety of persons to Follow these instructions. Save these instructions.
— do not allow children to play with fixed controls. Keep remote controls away from children;
— Frequently examine the installation for imbalance and signs of wear or damage to cables and springs.
Do not use if repair or adjustment is necessary;
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge.
unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
®
CONNECT & ENJOY
Projection Screen. User Manual

Advertisement

Table of Contents
loading

Table of Contents