Security + ELITE 3840 Owner's Manual page 22

ALL ONE-PIECE DOORS
1. Assemble the Door Arm:
• Fasten the straight and curved door arm sections
together to the longest possible length (with a 2 or 3
hole overlap).
• Make sure the garage door is fully closed. Connect the
straight door arm section to the door bracket with the
5/16"x1-1/4" clevis pin.
• Secure with a ring fastener.
• Pull the emergency release handle, disconnecting the
outer trolley from the inner trolley by pulling straight
down on the emergency release handle and sliding the
outer trolley back. See Figure 5.
• Connect the curved door arm section to the trolley
using the 5/16"x1-1/4" clevis pin and ring fastener.
• When setting the up limit on the following page, the
door should not have a "backward" slant when fully
open as illustrated below. A slight backward slant will
cause unnecessary bucking and/or jerking operation
as the door is being opened or closed from the fully
open position (Figure 6).
NOTE: Proceed to the following page to Program the
Travel Limits.
Figure 6
Inner Trolley
Correct Angle
Open Door
Figure 4
Door
Bracket
Clevis Pin Straight
5/16"x1-1/4" Arm
Bolts
5/16"-18x7/8
Figure 5
Inner Trolley
Door Arm
Connector Hole
Door Arm
Closed
Door
Door Arm
Connector Hole
Door with
Backward Slant
(Incorrect)
22
Ring
Fastener
Nuts
Lock
5/16"-18
Washers
5/16"
Outer Trolley
Emergency
Release Handle
Outer Trolley
Curved
Door Arm