Lifting And Moving The Tv; Setting Up The Tv; Attaching The Stand - LG 79UG880T Owner's Manual

16
ASSEMBLING AND PREPARING

Lifting and Moving the TV

When moving or lifting the TV, read the following
to prevent the TV from being scratched or
damaged and for safe transportation regardless
of its type and size.
CAUTION
Avoid touching the screen at all times, as
y y
this may result in damage to the screen.
Do not place the product on the floor with
y y
its front facing down without padding.
Failure to do so may result in damage to
the screen.
It is recommended to move the TV in the
y y
box or packing material that the TV originally
came in.
Before moving or lifting the TV, disconnect
y y
the power cord and all cables.
When holding the TV, the screen should
y y
face away from you to avoid damage.
Hold the top and bottom of the TV frame
y y
firmly. Make sure not to hold the transparent
part, speaker, or speaker grill area.
Use at least two people to move a
y y
large TV.
When transporting the TV by hand,
y y
hold the TV as shown in the following
illustration.
When handling the TV, be careful not to
y y
damage the protruding joystick button.
When transporting the TV, do not expose
y y
the TV to jolts or excessive vibration.
When transporting the TV, keep the TV
y y
upright; never turn the TV on its side or tilt
towards the left or right.

Setting up the TV

You can mount your TV to a wall or attach
the stand if you wish to place the TV on an
entertainment center or other furniture.

Attaching the Stand

If you are not mounting the TV to a wall, use the
following instructions to attach the stand.
CAUTION
When attaching the stand to the TV
y y
set, place the screen facing down on a
cushioned table or flat surface to protect
the screen from scratches.
Make sure that the screws are fastened
y y
tightly. (If they are not fastened securely
enough, the TV may tilt forward after
being installed.)
Do not tighten the screws with too much
y y
force; otherwise they may be damaged
and come loose later.
NOTE
Remove the stand before installing the TV
y y
on a wall mount by performing the stand
attachment in reverse.
Remove the protective film from the stand
y y
base and then attach the stand body to
the stand base. (For UC970T series)