Table of Contents
Advertisement
Available languages
Available languages
ADJUSTING CONTROL SETTINGS
In order to obtain stable temperature, the air must flow
between the freezer and refrigerator sections. As shown
in the illustration below, the cold air enters through
the bottom part and circulates upward. This air returns
below the freezer floor and the rest of the air enters the
refrigerator section through the top vent.
DO NOT block any of these vents with packages of food.
This can interrupt the flow of air and cause temperature
and moisture problems.
IMPORTANT: Because air circulates between both
sections, any odors formed in one section will transfer
to the other. You must thoroughly clean both sections to
eliminate odors. To prevent odor transfer and drying out
of food, make sure you wrap or cover foods tightly (See
the "Food Storage Guide" section for details).
NOTE: If you close the fresh food compartment door
applying more force than necessary, freezer door may get
open and close again, due internal air flow of refrigerator.
ADJUSTING THE CONTROLS
• Your refrigerator has two controls that allow you to
regulate the temperature the freezer and refrigerator
compartments.
• Refrigerator Control
Initially set the Refrigerator
Control
on
the
middle
setting (number 3). For
doing this, press the button
until the third light is on.
This temperature is the
recommended one for the
optimum refrigerator performance.
USING YOUR REFRIGERATOR
CONTROL DE TEMPERATURA REFRIGERADOR
(
)
MENOS FRIO
MAS FRIO
(
)
(
)
Leave the refrigerator on this setting for 24 hours to
reach the correct temperature. After 24 hours, adjust the
compartment temperature as you desire. ALWAYS wait
24 hours before you adjust the temperature. If you want
to set the refrigerator compartment temperature to a
warmer temperature than the current, continue pressing
the button until it reaches the desired temperature.
For obtain the minimum
temperature,
press
button until the first light is
on.
For the highest temperature,
press the button until the
maximum level lights are
on.
• Freezer Control
The freezer control should
come from factory on the
middle
setting
(number
5). Wait 24 hours before
adjusting
the
compartment
temperature.
Roll the knob to set the
freezer temperature as you
desire. ALWAYS wait 24 hours
after any adjustment to reach
the desired temperature.
For
obtain
the
minimum
temperature,
position
knob in number 1.
For the highest temperature,
set the knob in position
number 9.
NOTE: Setting at higher number of the Freezer
compartment, the temperature of freezer compartment
becomes colder.
10
CONTROL DE TEMPERATURA REFRIGERADOR
(
the
MENOS FRIO
MAS FRIO
(
)
CONTROL DE TEMPERATURA REFRIGERADOR
(
MENOS FRIO
MAS FRIO
(
)
FREEZER / CONGELADOR
TEMP CONTROL
1
LESS COLD/MENOS FRIO
5
NORMAL
freezer
9
COLDER/MAS FRIO
FREEZER / CONGELADOR
TEMP CONTROL
the
1
LESS COLD/MENOS FRIO
5
NORMAL
COLDER/MAS FRIO
9
FREEZER / CONGELADOR
TEMP CONTROL
1
LESS COLD/MENOS FRIO
5
NORMAL
COLDER/MAS FRIO
9
)
(
)
)
(
)
Advertisement
Chapters
Table of Contents
