Laser PB-2200LED Quick Start Manual

PB-2200LED
Product connection and use
What's in the box
Back up Battery, Micro USB cable (for charging), Quick start guide (this document),
Charging the Power Bank
Using the Micro USB cable provided to connect your PB-2200LED to a USB charger. The LED light display will then start to
flash. When charging has finished, the LEDs will stop flashing. It is recommended that you charge the unit overnight before
the first use, the top-up charge as needed.
On/Off button
To turn the device ON, press the power button until the LED lights turn ON.
To turn the device OFF, press the power button until the LED lights turn OFF.
Charging from your power bank
Connect your power bank to your portable device and press the power button. Your portable device will then begin
char4ging.
Product Specification
USB Input: 5V / 1A, Output 5V / 1A, Capacity 2200mah. Suits any device that is charged via USB. Contains circuitry to protect
against over-charge, over-discharge and short-circuits.
QUICK START GUIDE
Power Press to display battery charge staus on the LED
Button indicators
With repeated presses, the torch will: Turn ON, then
Torch
goto 50% Brightness, then Turn Off. Press and hold
Button
the button to enter SOS (flashing) mode.
LED Displays battery status at:
Indicators 4 LEDs 100%, 3 LED's 75%, 2 LED's 50%, 1 LED 25%.
Connect any device using a USB cable and press the
Output
power button to begin charging.
Input Connect to a USB charger to charge the battery