Connect To The 3Com Email Firewall Via A Web Browser - 3Com 3CR3MFA-92 Installation Manual

14 C 2: I
HAPTER NSTALLING THE
Connect to the 3Com
Email Firewall via a
Web Browser
3C E F
OM MAIL IREWALL
Connecting your 3Com Email Firewall and computer directly using
■
a crossover cable.
Connect to the 3Com Email Firewall from your configuration computer as
follows:
1 Ensure the 3Com Email Firewall and your computer are properly
connected on the network either directly or via a hub or switch.
2 Turn on the power of the 3Com Email Firewall. Wait at least 1 to 2
minutes for the system to fully start before trying to connect.
3 The default IP address used by the 3Com Email Firewall is 192.168.1.253.
Reconfigure your computer's local network settings to use an address on
the same network. Use the IP address 192.168.1.252 with a subnet mask
of 255.255.255.0.
See Appendix A on
IP address.
If there are existing systems on the network using these addresses, use a
crossover Ethernet cable to connect the computer and 3Com Email
Firewall together as an isolated connection.
4 Launch a web browser on your computer and enter 192.168.1.253 as
the URL in the location bar.
5 Login using the username admin with the default password of admin.
The Welcome screen of the Setup Wizard will then be displayed.
page 31 for instructions on changing your computer's