Install The Soundtrap Host On Your Pc; Connect Soundtrap To Your Pc - Ocean Instruments SoundTrap ST400 User Manual

2.4 Install the SoundTrap host on your PC

To start using your SoundTrap you'll need to install the SoundTrap Host software.
For correct operation of your ST400 it is critical to use SoundTrap Host version 4.0.0 or
later.
•
Pre-installation Notes:
o The SoundTrap host software supports Windows 7, 8 & 10 (32 or 64 bit versions).
o Do not connect the SoundTrap to your computer until you have completed the
SoundTrap host software installation.
o The installation will be smoother if you're logged into windows as an administrator.
•
Visit www.OceanInstruments.co.nz/downloads/
•
Download and run the installer.
•
Once the install completes, run the SoundTrap Host application.

2.5 Connect SoundTrap to your PC

•
Connect the SoundTrap using the USB cable provided.
•
The drivers will take a couple of minutes to install. Once complete you should see your
SoundTrap appear in the 'Device List' on the left, as shown in figure 3.
•
Select your SoundTrap by clicking its label on the left.
to download the software.