Sanyo PLC-XU10E Owner's Manual page 14

CONNECTING THE PROJECTOR
CONNECTION TO THE MACINTOSH COMPUTER
To connect with the Macintosh computer, refer to the figure below.
Use Cables and Adapter indicated below.
· VGA CABLE (supplied)
· VGA/MAC ADAPTER (supplied)
· MOUSE CABLE FOR ADB PORT (supplied)
· MONITOR CABLE (not supplied)
· PC AUDIO CABLE (stereo / not supplied)
NOTE :
When connecting the cable, the power cords of both the projector and the external equipment should be
disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched
on.
MACINTOSH COMPUTERS (VGA / SVGA / XGA / SXGA)
To the Monitor
14
Desktop type
Monitor
Monitor Output
MAC Adapter (supplied)
Set the switches depending
ON
DIP
on the RESOLUTION MODE
1 2 3 4 5 6
that you want to use before
your turn on the projector and
computer
VGA Cable (supplied)
Monitor Cable (not supplied)
Laptop type
To each terminal of your computer
ADB port Audio Output
Terminal
Audio Speaker
(stereo)
Audio Amplifier
Audio Input
Audio Cable
(stereo / not supplied)
Mouse Cable for ADB Port (supplied)