Table of Contents
Advertisement
Available languages
Available languages
E N G L I S H
Also refer to the table below.
Conductor size (mm
2
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Mounting and removing an accessory (fig. A)
This tool uses inner thread core bits and adaptors
which thread directly onto the spindle with a right-
hand thread.
Follow the core bit or manufacturer's
recommendations for mounting the
accessory.
• Make sure the entire assembly is tight before
drilling.
Fitting the side handle (fig. B)
The side handle (5) can be fitted to suit both RH-
and LH-users.
Always use the Drill with the side handle
properly assembled.
en - 5
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
• Twist the side handle to loosen it.
• For RH-users, slide the side handle clamp over
the 53 mm collar, handle at the left.
• For LH-users, slide the side handle clamp over
the 53 mm collar, handle at the right.
• Rotate the side handle to the desired position
and tighten the handle.
Two gear selector (fig. A & C)
The tool is fitted with a two gear selector (6).
60
• Release the switch and select the required position
6
10
after the motor has come to a complete standstill.
15
• Always align the selector with the arrow on the
gear housing:
20
25
o low speed
-
oo high speed
-
-
6
6
6
6
For speed rates, refer to the technical data.
15
15
20
-
Instructions for use
• Always observe the safety instructions
• Be aware of the location of pipework and
• Apply only a gentle pressure to the tool.
Prior to operation:
• Mount the appropriate accessory.
• Mark the spot where the hole is to be drilled.
Switching ON and OFF (fig. A)
Variable speed switch
• To run the tool, press the variable speed switch.
The pressure exerted on the variable speed
switch determines the tool speed.
DW590K - Lock-on button (when rig-mounted)
• For continuous operation, press and hold down
the variable speed switch, press the lock-on
button (2) and release the switch.
Do not try to change gears when tool is
running.
and applicable regulations.
wiring.
Excessive force does not speed up
drilling but decreases tool performance
and may shorten tool life.
18
Advertisement
Chapters
Table of Contents
