Beko DSN28520X User Manual page 34

Operating the product
Changing the settings while Time
Delay function is enabled
While the Time Delay function is activated,
you cannot make changes in the washing
programme, auxiliary functions or the
duration of delay time.
C
Programme and auxiliary
functions cannot be set/
changed after the programme
has started.
To cancel the Time Delay function
1. Press and hold Start / Pause / Cancel
key for 3 seconds.
2. When the Start / Pause / Cancel key
is pressed and hold, "3", "2", "1" appear
on the Display Information Line. Time
Delay indicator will turn off at the
end of the cancellation process and
delaying process is cancelled.
C
You can select and start a
new programme following the
cancellation of Time Delay
function.
C
Time Delay function can not be
set after the programme starts.
Starting the programme
To start your machine after selecting the
programme and auxiliary functions, press
Start / Pause / Cancel key.
Once the programme starts a tune is played
and the estimated time remained to the
end of the programme will appear on the
Display Information Line. Start / Pause /
Cancel indicator starts lighting continuously.
34 /44 EN
C
Your machine performs water
softening depending on the
hardness level of the supply
water. Remaining time displayed
towards the end in some
programmes can be different
from the time indicated at
the beginning due to this
process. The total time can also
change while the programme
is running depending on the
ambient temperature where
your machine is installed,
temperature of the supply
water and amount of the dishes.
C
Pay attention not to open the
door of the machine when it is
running. Stop the machine by
pressing Start / Pause / Cancel
key if you have to open the
door. Then, open the door of
the machine. There may be a
rush of steam when you open
the door of your machine; be
careful. Close the door of your
machine and press Start/Pause/
Cancel key again. Programme
will resume running.
C
The machine will remain silent
in pause mode for some time
in order to remove the water in
the machine and on the dishes
completely and to have the
water softener cleaned, and
then it will resume running in
drying mode.
Dishwasher / User's Manual