Table of Contents
Advertisement
No draining
After insert the plug, turn the
sequencer knob to the drain location
Check if the drain pump acts.
Check if the drain motor is normal
Check the inset is normal
and measure the voltage of two ends of
the drain motor
Check if the wire unit is normal
Replace the sequencer
Keep filling water
Open the water faucet without switching on the power.
If the water can fill into the water inlet valve.
check if the gas guide system such
as gas cell leaks gas
Replace the water level sensor.
MAINTENANCE SERVICE AND TROUBLE SHOOTING
No
No
Exist
Yes
No
No
Check the inset is normal
No
and measure the voltage of two ends of
the drain pump
Check if the wire unit is normal?
Replace the sequencer
Yes
Replace the water inlet valve.
Yes
It leaks gas. Please check and repair the gas guide system.
Please smear 801 glue in installation of the connecting pipe.
Please smear 801 glue in installation of the gas cell cover.
Exist
Replace the drain pump
No
Exist
No
Repair or replace the wire unit
Yes
Advertisement
Table of Contents
