Operation - Universal Tool UT8749S-1 General Safety Information & Replacement Parts

Operation

1
Operating the sander
□ This Angle Sander is designed to operate on 90 PSIG.
Lower pressure (below 90 PSIG) will reduce performance
of the tool. Higher air pressure (over 90 PSIG) raises the
performance of the tool beyond its rated capacity and
could cause serious damage to the tool and the user.
3
Removing the sanding pad
WARNING: Disconnect the tool from the air source before
servicing or changing any accessories.
□ Unlock the drive spindle and rotate to remove the sanding pad.
Spindle Lock
2
Installing the sanding pad
WARNING: Disconnect the tool from the air source before
servicing or changing any accessories.
WARNING: Always use the sanding discs with the rated
tool RPM.
□ Lock the drive spindle in place before attaching the sanding
pad. Rotate the spindle lock until the spindle lock engages
with the drive spindle. Hand tighten the sanding pad in a
clockwise direction.
4
Sanding surfaces
WARNING: You must wear ANSI approved eye protection
during the operation; failure to follow this may result in
serious injury or damage to the operator.
WARNING: Hearing protection is strongly recommended. A
protective respirator is recommended.
□ Connect the sander to the air supply.
□ This tool features a safety lock-off mechanism.
□ Operate the tool by disengaging the safety lock-off
mechanism and depressing the throttle lever to run the
tool for sanding.
Please contact 1-800-356-3392 for further assistance.
Spindle Lock
FLORIDA-PNEUMATIC.COM