Operation - Universal Tool UT8892 Series General Safety Information & Replacement Parts

Operation

1
Operating the drill
This 3/8" Reversible Pistol Grip Drill is designed to operate
on 90 PSIG. Lower pressure (below 90 PSIG) will reduce
performance of the tool. Higher air pressure (over 90
PSIG) raises the performance of the tool beyond its rated
capacity and could cause serious damage to tool and user.
3
Removing the bits
WARNING: Disconnect tool from air supply before servicing
or changing accessories.
To remove the bits:
Remove the air supply from the reversible drill.
Using an appropriately sized chuck key, turn the chuck key
counterclockwise to loosen the drill bit, tap, or reamer in
the drill chuck.
Remove the bit.
2
Installing and removing the bits
WARNING: Disconnect tool from air supply before servicing
or changing accessories.
To install the bits:
Remove the air supply from the reversible drill.
Insert the drill bit as far as possible into the opening.
Using an appropriately sized chuck key, turn the chuck key
clockwise to securely tighten the drill bit, tap, or reamer in
the drill chuck.
Always remove the chuck key before connecting the drill to
the air line.
4
Driving or removing screws
Place the rotation direction switch in the correct position
(forward or reverse) for the operation.
Hold the reversible drill with one hand.
Place the bit on the screw head and slowly depress the
switch trigger. Start the bit slowly for more control.
Please contact 1-800-356-3392 for further assistance.
FLORIDA-PNEUMATIC.COM