When you turn the TV on for the first time, a sequence of on-screen prompts will assist in configuring basic settings. To turn on
the TV, press the POWERP button.
Plug & Play is available only when the Source is set to TV.
To return to the previous step in the Plug & Play sequence, select Previous, and then press ENTERE.
Before turning on the TV, make you have connected the TV to an antenna or cable connection (p. 8).
Selecting the OSD
Selecting the usage
Setting the Clock
options for auto tuning
Network Setting / Enjoy
If You Want to Rerun Plug & Play...
→ System → Plug & Play → ENTERE
y To change the TV's setting from Store Demo to Home Use when not in Plug & Play, press the volume button on the TV.
When you see the volume bar on the screen, press and hold the
Plug & Play (Initial Setup)
Press the ▲ or ▼ button to select a language. Press ENTERE twice
Press the ▲ or ▼ button to select, and then press the ENTERE button
y Select the Home Use mode. Store Demo mode is for retail
Press the ▲ or ▼ button to select Auto or Manual, and then press
If you selected Auto, you'll go to the Time Zone and DST screen. Select Time Zone
or DST, and then press ENTERE. On the Time Zone screen, use the ▲ or ▼
button to select your zone, and then press ENTERE. On the DST screen, press,
ENTERE, then select whether to turn DST (Daylight Savings Time) on or off. When
done, press ENTERE.
If you selected Manual, you'll go to the Date and Time screen. Select Date or Time,
and then press ENTERE. Then, use the number buttons or the ▲ or ▼ button to
set the date or time. Use the ◄ or ► button to move between entry fields. When
done setting the Date and Time, select Next, and then press ENTERE.
Press the ▲ or ▼ button to select Air or Cable, and then press ENTERE. A check
appears on your selection. Select Next, and then press the ENTERE button. You can
check both if you have both connected.
If you selected Cable, you'll go to the Cable System screen. Use the ▲ or ▼
button to select Digital or Analog, and then press. ENTERE. Use the ▲ or ▼
button to select the correct cable signal format - STD, HRC, or IRC - and then press
ENTERE. Most cable systems use STD. Select the correct cable signal format for
both the Digital and Analog systems.
When done, select Next, and the press ENTERE.
The channel search will start automatically. This can take up to 30 minutes.
For more information, refer to Channel → Auto Program in the e-Manual.
Press the ENTERE button at any time to interrupt the memorization process.
If you want to watch a broadcast program, select Enjoy your TV. You can also set up
the Network connection. If you want to set up the network, select Network Settings.
The Network Settings screen will appear. For more detailed information, refer to "Network
Connection" in the e-Manual.
English - 10
button on the TV for 5 sec.