Table of Contents
Advertisement
4.3.5 Equipotential
The appliance must be hooked up to a unipotential system.The
required terminal is located near the power cable and it is marked
by a tag with a symbol
.
The manufacturers cannot be held responsible for any dam-
age due to inadequate or incorrect installation. Under such
circumstances the guarantee will be considered null and void.
5.1 Preparation and Start-up
Before starting up the appliance, remove the protective wrapping.
Then carefully clean the working surface and the external parts with
lukewarm water and detergent, using a damp rag to remove all traces
of anti-rust material applied in the factory, then dry with a clean cloth.
5.1.1 Start-up
To start up the appliance, see the instructions for regular use.
5.1.2 Operator training
• Explain and show the user how the machine works according to
the instructions, and hand him this manual.
• Remind the user that any structural alterations or any building
modification or renovation may affect the combustion air supply,
thus requiring a second operation check.
5.2 Maintenance
Attention! Before doing any repair or maintenance
work, unplug the appliance.
• Never leave the hotplates on unused!
• Only use flatbottomed pots and pans, and make sure that the
diameter of the pan is never smaller than the diameter of the
hotplate it is being used on.
5.3 Replacing parts
All parts must be replaced by authorized technicians
only!
To replace the following parts first remove all the control knobs and
control panel (after loosening the fixing screws), then extract the
ignition wire.
5.3.1 Heating element of electric oven GN 1/1
Unplug the appliance from the electrical mains!
To remove the heating element (pos. 6 fig. 2), remove the rear bulk-
head, unscrew the screws fixing the the heating element to the
oven, pull the heating element forward with relative wires.
Disconnect the wires, and install a new heating element in reverse order.
0801_GB_42 - ELECTRIC KITCHENS
4 - INSTALLATION INSTRUCTIONS
5 - SET-UP FOR OPERATION
5.3.2 Fan of of electric oven GN 1/1
Unplug the appliance from the electrical mains!
To replace the fan remove the back unscrew the sight screws, discon-
nect the wires from the motor, from the inside of the chamber
remove the rear bulkhead fan cover and the fan (pos. 1 fig. 2) by
loosening the locking nut (pos. 2 fig. 2 "NB. the nut is with left
thread").
Loosen the bolts (pos. 3 fig. 2) hat hold the motor (pos. 4 fig. 2) on
the oven and pull off from rear. Re-install in reverse order position-
ing in the correct way the seal protection (pos. 5 fig. 2) and power
mains.
9 · 20
After any maintenance or repair work, replace the con-
trol panel and the lower panel.
04/2008
Advertisement
Table of Contents
