Advertisement
2 - NUMBERING
Each transmitter is manufactured and sold with a different factory set
sequence number and facility code.
3 - PROGRAMMING
The transmitter facility code and sequence number must be
programmed into your system memory. Your own installer or reseller will
provide you the necessary instructions for your system.
4 - OPERATION
a. Firmly depress either button until the small red LED illuminates.
b. After the LED has illuminated, release the button. If the device you are
attempting to activate does not respond, repeat steps a. and b. or
consult section 6 (Troubleshooting) of this manual.
5 - BATTERY ACCESS
2 X CR2016
Fig. 2
To access the battery act on the top with an edge and open the box (fig.2).
Place the 2 batteries CR2016 with the positive pole upward.
NOTE: Please dispose of the batteries properly according to local laws and
regulations.
Test proper battery installation by verifying that the red LED illuminates when
either button is pushed.
ATTENTION ! - Danger of explosion if
the battery is not replaced in the
correct way! Replace only with an
equal or equivalent type!
Side (+)
Side (-)
6 - TROUBLESHOOTING
Fault
The system does not receive the transmitter
signal
The transmitter led is OFF
The transmitter led is blinking
The operating range is reduced
The system does not receive the transmitter
signal
The transmitter led is ON.
Any changes or modification to
expressly approved by
Transmitter Solutions
manufacturer's warranty.
WARRANTY
The warranty period of
Transmitter Solutions
months, beginning from the manufacturing date of the transmitter.
During this period, if the product does operate correctly, due to a
defective component, the product will be repaired or replaced at the
sole discretion of Transmitter Solutions.
The warranty does not extend to the transmitter case which can be
damaged by conditions outside the control of Transmitter Solutions or to
battery life.
Solution
Replace the transmitter
battery
Check the power supply
of the receiver
Notice
Transmitter Solutions
equipment not
could void the
318 transmitters is 24
TRANSMITTER SOLUTIONS
2505 Chandler Avenue, Suite, 1
Las Vegas, NV 89120 -
(866) 975-0101 - (866) 975-0404 Fax
sales@transmittersolutions.com
IS-T053TSUK Rev. 2 del 15.7.2010
Advertisement
