Table of Contents
Advertisement
DIR-615 Wireless N300 Router
User Manual
In the opened window, you can specify the following parameters:
Parameter
Protocol
Interface
Destination network
Destination netmask
Gateway
Metric
After specifying the needed parameters, click the SAVE button.
To edit an existing route, select a relevant line of the table. On the opened page, change the needed
parameters and click the SAVE button.
To remove an existing route, select the checkbox located to the left of the relevant line in the table
and click the DELETE button (
A protocol that the route will use.
From the drop-down list, select an interface through which the
destination network can be accessed. If you have selected the Auto
value, the router itself sets the interface on the basis of data on
connected networks.
A destination network to which this route is assigned. You can specify
an IPv4 or IPv6 address.
You can specify an IPv6 address (2001:db8:1234::1) or an IPv6
address with a prefix (2001:db8:1234::/64).
For IPv4 protocol only.
The destination network mask.
An IP address through which the destination network can be accessed.
A metric for the route. The lower the value, the higher is the route
priority. Optional.
).
Page 138 of 176
Configuring via Web-based Interface
Description
Advertisement
Table of Contents
