Page 1
INSTRUCTION MANUAL 20 x FRAME BEEHIVE BK-HPDH20 IMPORTANT • Please read through instructions prior to constructing beehive • Ensure you have all listed parts and tools required for set up before beginning • A clean workplace is required for safe and easy construction of your beehive •...
Page 2
NOTE FROM SUPPLIER: Please check and ensure you have all parts listed and tools required before commencing construction of your beehive. Tools required: Hammer, Rubber Mallet, Pencil, and Measuring Tape PART # PART NAME 1x Assembled Lid 1x Base board 20x Frame Top Bar 2x Cleats 40x Frame Side Bar...
Page 3
Step 1: Marking Lines 14cm Place the Base Board down on your workspace. See Diagram 1 to identify where 14cm you need to use your pencil to mark where the cleats will be placed. Diagram 1 Note: The side which is facing upwards to you will form the outside base of your beehive.
Page 4
Step 4: Base Board Riser Gather the base board part No. 3, 4, 5 & 4 x 25mm nails. Step 5: Nailing Base Board Riser Place and nail the corners as shown in Diagram 5. Diagram 5 Step 6: Aligning to Base Board Place your assembled Base Board your assembled...
Page 5
Step 8: Beehive Supers Using a rubber mallet, assemble your beehive Supers by aligning the joints as shown in Diagram 9 and hammer into place. Use 20 x 40mm nails to secure the walls together. Repeat Step 8 with remaining supers. Diagram 9 Step 9: Attaching Base to Supers Turn your assembled beehive upside...
Page 6
Place 10 assembled beehive frames in the completed beehive, then place the second completed Beehive Box on top & insert 10 remaining frames. Complete assembly by placing the pre-assembled lid on top. END OF BEEHIVE CONSTRUCTION Whitehouse Whitehouse BEEKEEPING BEEKEEPING...