Table of Contents
Advertisement
Preparation
C
The best washing performance
in dishwashers is obtained by
using detergent, rinse aid and
water softening salt individually.
When you switch to powder, liquid/gel or
tablet detergent from a combined tablet
detergent:
1.
Make sure that salt and rinse aid
reservoirs are full.
2. Set the water hardness to the highest
level and perform an empty run.
3. After the empty washing cycle, review
the user manual and readjust the water
hardness level so as to suit the water
supply.
4. Make the appropriate rinse aid settings.
C
Depending on the model,
salt indicator and/or rinse aid
indicator must be enabled again
if they were disabled before.
Rinse aid
C
The rinse aid used in
dishwashers is a special
combination used to increase
drying efficiency and prevent
water or limescale stains on the
washed items. For this reason,
care must be paid to have rinse
aid in the rinse aid reservoir
and to use rinse aids produced
specially for dishwashers only.
1.
Open the lid of the rinse aid reservoir
by pressing its latch (B).
Dishwasher / User's Manual
2. Fill the reservoir until "MAX" level.
3. Turn the rinse aid amount adjuster
manually to a position between 1 and
6 (4). If there are stains on tableware
items after washing, level must be
increased and if there is a blue trace
after wiping them by hand, it must be
decreased. This is set to position 4 as
factory default.
4. Close the lid of the reservoir by
pressing on it lightly.
C
Wipe clean any spilled rinse
aid outside the reservoir. Rinse
aid that spilled accidentally
will cause foaming and it will
eventually decrease washing
performance.
17 / 35 EN
Advertisement
Table of Contents
