Table of Contents
Advertisement
Make sure to close the computer cover before connecting the
power after a reassembly.
There is a danger of electric shock if your body touches an internal
part.
Use parts authorized by Samsung Electronics only.
Failure to do so, may cause fire or damage the product.
Never disassemble or repair the product by yourself.
There is a danger of electric shock or fire.
To connect a device that is not manufactured or authorized
by Samsung Electronics, enquire at your service center before
connecting the device.
There is a danger of damaging the product.
Replacement Parts and Accessories
Use only replacement parts and accessories recommended by
manufacturer.
To reduce the risk of fire, use only No. 26 AWG or larger
telecommunications line cord.
Do not use this product in areas classified as hazardous.
Such areas include patient care areas of medical and dental
facilities, oxygen rich environments, or industrial areas.
Battery Disposal
Do not put rechargeable batteries or products powered by
non-removable rechargeable batteries in the garbage.
Contact the Samsung Helpline for information on how to dispose of
batteries that you cannot use or recharge any longer.
Follow all local regulations when disposing of old batteries.
THERE IS A RISK OF EXPLOSION IF BATTERY IS REPLACED BY
AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE
INSTRUCTIONS.
Laser Safety
All systems equipped with CD or DVD drives comply with the
appropriate safety standards, including IEC 60825-1. The laser devices
in these components are classified as "Class 1 Laser Products" under
a US Department of Health and Human Services (DHHS) Radiation
Performance Standard. Should the unit ever need servicing, contact an
authorized service location.
●
Laser Safety Note:
Use of controls or adjustments or performance of
procedures other than those specified in this manual
may result in hazardous radiation exposure. To prevent
exposure to laser beams, do not try to open the enclosure
of a CD or DVD drive.
●
Class 1M laser radiation when operating part is open.
Do not view directly with optical instruments.
●
Class 3B invisible laser radiation when open.
Avoid exposure to the beam.
Security and Movement Related
When moving the product, turn the power off and separate all
connected cables first.
The product might be damaged or users may trip over the cables.
For long periods of not using the notebook computer, discharge
the battery and preserve as it is detached. (For external &
removable battery type)
The battery will be preserved at its best condition.
Do not operate or watch the computer while driving a vehicle.
There is a danger of a traffic accident. Please concentrate on driving.
Connect and Disconnect the AC adapter
The socket-outlet shall be installed near the equipment and shall be
easily accessible.
Do not unplug the power cord by pulling the cable only.
Power Cord Requirements
The power cord set (wall plug, cable and AC adapter plug) you
received with your computer meets the requirements for use in the
country where you purchased your equipment.
Power cord sets for use in other countries must meet the requirements
of the country where you use the computer. For more information on
power cord set requirements, contact your authorized dealer, reseller,
or service provider.
General Requirements
The requirements listed below are applicable to all countries:
●
All power cord sets must be approved by an acceptable accredited
agency responsible for evaluation in the country where the power
cord set will be used.
●
The power cord set must have a minimum current capacity of 7 A
and a nominal voltage rating of 125 or 250 volts AC, as required by
each country's power system. (USA ONLY)
●
The appliance coupler must meet the mechanical configuration
of an EN 60 320/IEC 320 Standard Sheet C7 (or C5) connector, for
mating with appliance inlet on the computer.
27
27
Advertisement
Table of Contents
