Related Manuals for Hongli A200
Summary of Contents for Hongli A200
- Page 1 Model: A200 Drain Cleaning Machine Operation Manual WARNING! Read this Operator’s Manual carefully before using this tool. Failure to understand and follow the contents of this manual may result in electrical shock, fire and/or serious personal injury.
-
Page 2: General Safety Information
General Safety Information WARNING! Read and understand all instructions. damaged cords immediately. Damaged cords Failure to follow all instructions listed below may increase the risk of electrical shock. result in electric shock, fire, and/or serious personal • When operating a tool outside, use an outdoor injury. - Page 3 Read this operator’s manual carefully before using • Do not use tool if switch does not turn it ON or the A200 Drain Cleaner. Failure to understand and OFF. Any tool that cannot be controlled with the follow the contents of this manual may result in switch is dangerous and must be repaired.
- Page 4 OFF position.(Figure 1) • Only use the A200 to clean drain lines up to 8″ in diameter. Follow instructions on the use of the machine. Other uses or modifying the drain cleaner for other applications may increase the risk of injury.
- Page 5 2. Inspect the power cord and plug for damage. If WARNING the plug has been modified, is missing the Do not place machine in water. Water entering grounding prong or if the cord is damaged, do not the motor can result in electrical shock. use the Drain Cleaning Machine until the cord has To prevent serious injury, proper set-up of the been replaced.
- Page 6 Never couple more than one cable at a time. Cable 5. Check that the adapter stops instantly when will extend behind rear guide tube. clutch handle is pulled upward. If adapter coasts, 6. Select and install the proper tool to the end of the see Special Procedures section to adjust brake.
- Page 7 clutch is instant-acting and returning clutch handle to • After reaching the end of each cable section, turn its original position frees cable instantly. the machine OFF. 6. As soon as excess cable has gone into line, • Secure the cable by looping it in the line (Fig 5.) release clutch handle and pull six to ten inches of cable out of machine with mitted hand.
- Page 8 13. Pull remaining cable and tool from sewer. When not in use, store cables indoors to prevent After using, thoroughly flush and drain cables, deterioration by the elements. couplings and tools with water due to damaging Cables should be replaced when they become effects of some drain cleaning compounds.
Need help?
Do you have a question about the A200 and is the answer not in the manual?
Questions and answers